amzchef ZM1501 Mode D'emploi page 7

s. The food material needs to be cut into proper pieces so as to pass
through the inlet to extractor/chopper/grind. Any fruit/vegetable shall
have any hard core, seed, skin or shell removed before processing.
Proper amount of force shall be used to push the food material in, not
9.
excessive but sufficient to have it cut off exactly.
The juice filter, extractor cover, or auger may be dyed by the juice
10.
during operation, which is a normal phenomenon and has no effect on
edibility and does no harm to health.
This product is equipped with intelligent protection chips, making it stop
11.
automatically for every 20 minutes' operation. And in such case, rest it for
20-30 minutes before restarting it, so as to cool the motor down and
prolong product servicelife.
This product is designed to limit the flow rate. During processing of
12.
any hard material, the motor will be locked and the current will rise up.
When the current goes higher than 1.3A, the equipment will beep
and the motor will stop operation for over-current protection and
extension of life span.
In case that current limit protection is triggered or the motor is locked
13.
and stops automatically, disconnect the power supply and keep the
switch in position "0", and press Rotate Backwards button on the power
switch, and then discharge the food material and then press Rotate
Forwards to restart the machine. If the problem continues, it is
recommended to remove any food material inside auger before restart
so as to protect the motor.
After the completion of operation, remove any removable part
14.
only after the motor/auger/shredder/slicer/grinder screw has
stopped rotating and the power has been disconnected.
Any part in contact with food material is clean, safe and reliable in
15.
compliance with related food hygiene codes.
To protect against risk of electrical shock, do not put the motor base in
16.
water or other liquid.
7