Before Using Your Device; Treatment Areas - Nuface Trinity Mode D'emploi

Dispositif tonifiant visage
Masquer les pouces Voir aussi pour Trinity:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BEFORE USING YOUR DEVICE

1. Connect the external power adaptor to the charging cradle and plug adaptor
into the wall outlet.
2. Place your Trinity device on the charging cradle.
3. When you hear an ascending beep and the blue lights increasingly illuminate,
your device is charging.
4. Charge your Trinity device for 12 hours before the first use. The blue lights will
stay illuminated when fully charged.
5. A fully-charged device should last for approximately two weeks of use based on
a daily 20-minute treatment time. If the battery power is drained completely, a
full charge cycle of 12 hours is recommended.
6. Firmly press the release button (#6 in "Getting to Know Your Device") to
remove or fasten the attachment. Guide the attachment in place (as pictured)
and then release the button to secure it.
7. Test your skin to make sure you are not sensitive to the NuFACE primer. Rub a
dime-sized amount of the primer on your forearm and leave for 15–30 minutes
before washing off. If an allergic reaction develops within 24 hours, you should
not use the device and/or treatment attachments in conjunction with the NuFACE primer. Consult
www.myNuFACE.com for the appropriate contact within your country to provide information on an
alternate conductive medium.
8. Before and after your treatment, take a photo of your clean face/problem areas in a well-lit room. Every
eight weeks, take another photo and compare results.
USAGE INSTRUCTIONS
INDICATIONS FOR USE
The Facial Trainer is intended for facial stimulation and is indicated for over-the-counter cosmetic use.
CONTRAINDICATIONS FOR USE
• Do not use if you have a history of epilepsy or seizures.
• Do not use if you have had recent facial surgery or other surgical procedure — consult your doctor.
• Do not use if you have an electronic implanted device such as a defibrillator, neurostimulator,
pacemaker, or ECG Monitor. If you use a body-worn medical device, such as an insulin pump — consult
your doctor prior to use.
• Do not use if you have any active cancer or over any suspicious or cancerous lesion — consult your doctor.
• Do not use if you are pregnant.
• Do not use on infants and children under the age of 18, and keep device and attachments out of the
reach of children.
TREATMENT STEPS
1. For best results, view the brief video at www.myNuFACE.com/how-to and follow all of the steps
indicated in the "Before Using Your Device" section.
2. Cleanse your face with an oil-free cleanser. Men should shave before treatment, as facial hair
can interfere with the conductivity of the spheres. Note: Oil-based products block penetration
of microcurrent.
3. Apply primer on your clean, dry skin to the designated areas being treated, only after a skin test
(refer to "Before Using Your Device" section). Important: Apply NuFACE Gel Primer in a mask-like
layer to one area at a time, beginning with the left cheek.
4. Power on by pressing the ON/OFF button.
5. Adjust the intensity level to your comfort by pressing the intensity control buttons. It is normal not to
feel any sensation when using the Trinity device.
6. Place the spheres in direct contact over the area to be treated. Always keep both spheres on your
face at the same time and glide and hold with medium pressure. The device emits a beep every five
(5) seconds to indicate when to move to the next treatment area. NOTE: The Trinity device will not
contract the muscles. The current is soft, very soothing, and mild when used correctly.
7. It is important not to allow the primer to dry during treatment. Reactivate the primer by applying
more primer to treatment area(s).
8. After treatment is complete, remove the primer with a damp cloth.
9. Turn off your device after every treatment; it will emit a descending beep. It will automatically turn
off after approximately 20 minutes of use.
2

TREATMENT AREAS

The Facial Trainer is designed to stimulate large surface areas of the face, such as the jawline, cheekbones
and forehead. The instructions below are designed to provide users with the most effective results when
followed correctly.
BASIC TREATMENT GLIDES (5 minutes)
Lift one side of the face at a time. Glide each position for 1 beep (5 seconds). Complete each sequence
3 times.
FACE
1. JOWL + JAW:
Place the bottom sphere on
the jawline with the top sphere slightly outside
the corner of the mouth. Slowly guide to the
hairline at the lower ear until the beep sounds
(5 seconds). Move to Position 2.
2. LOWER CHEEKS:
Place the bottom sphere
under the corner of the mouth with the top
sphere above the corner of the mouth. Slowly
guide to the hairline at the mid-ear until the
beep sounds (5 seconds). Move to Position 3.
3. UPPER CHEEKS:
Place the bottom sphere
outside the corner of the mouth with the top
sphere above the bottom sphere (both spheres
should be on the nasolabial fold). Slowly guide
to the hairline at the upper ear until the beep
sounds (5 seconds). DO NOT PLACE THE SPHERES
IN THE EYE AREA; GLIDE ALONG THE ORBITAL
BONE. Return to Position 1 and repeat.
Compare the treated side of the face to the untreated side, and look for improvement in the BROW,
CHEEKBONE and JAWLINE areas. Repeat treatment steps on opposite side of the face.
ATTENTION! Prior to use, view the instructional video at
www.myNuFACE.com/how-to
TREATMENT FREQUENCY
• Use 5 minutes a day.
• For the first 60 days, use 5 times per week.
• After 60 days, use 2-3 times per week for maintenance.
• Allow 24 hours between treatments.
RESULTS
Results may vary based on skin type and skin damage. Most users experience instant facial stimulation
benefits while others take longer. Optimal results are achieved with regular use.
Facial
Trainer
Spheres
FOREHEAD
1. THICK OF BROW:
Place both spheres
horizontally above the thick of the eyebrow.
Slowly glide upward toward the hairline until the
beep sounds (5 seconds). Move to Position 2.
2. ARCH OF BROW:
Place both spheres
horizontally, slightly above the arch of the
eyebrow. Slowly glide upward toward the
hairline until the beep sounds (5 seconds).
Move to Position 3.
3. THIN OF BROW:
Place both spheres
horizontally, slightly above the thin of the brow.
Slowly glide upward toward the hairline until
the beep sounds (5 seconds). Return to Position
1 and repeat.
=
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pro

Table des Matières