Gemm SPACE Série Notice D'utilisation page 52

7.6 – USE
- Press the
press the
for 3 sec the same key and then using the up and down arrow keys.
- A manual defrost can be selected; press and hold for 3 sec the
higher than +8°C, a manual defrost phase is activated. This phase ends either when the time of 20' has elapsed
or when the temperature measured by the evaporator sensor is (+8/+5°C Tn/BT). The automatic defrost,
managed by the thermostat, takes place once every 8H for a max. of 20' during which time the readout dEF is
shown on the display.
- With the keypad active, press keys
respectively, which are recorded by the sensor inside the cabinet. The displayed values are preceded by the
readouts LO and HY respectively. To reset this stored value, press and hold for 3 sec the
time it is displayed. On the display this reset is preceded by the readout RST (reset).
7.6.1 – SPECIAL USE
- With the keypad active, press and hold for 3 sec the
This phase lasts (1H) at a temperature (-2/-21°C TN/BT). These values are factory set in the controller. Unlike
the normal refrigerating phase, in this case the symbol
elapsed, the symbol will go out and the appliance will start once again to operate with the previous set point.
7.6.2 – LONG IDLE PERIODS
Turn the machine OFF by pressing
Clean the machine thoroughly (see paragraph 8.2) and make sure the door is left open at the end of the operation and
throughout the idle period.
EFN EFB_Rev.01 01-2014
key to display the set-point and change it if necessary;
key just once to display the set temperature, which can be changed by pressing and holding
and
for three seconds, then unplug.
key and if the evaporator temperature is no
just once to display the maximum and minimum temperature
key to activate the CONTINUOUS CYCLE phase.
on the display is lit. When the set time (1H) has
key at the
pag. 52