Drilling The Support Surface And Fitting The Hood - AEG Electrolux DL8560-M Mode D'emploi

17

Drilling the Support surface and Fitting the Hood

• The Hood can be installed directly on the under-
side of wall-mounted units (650 mm min. from
the Cooker Top) using the snap-on side supports
and screws provided.
• Create an opening in the bottom of the wall
mounted unit, as shown (fi g.1), leaving a distance
of at least 20mm from the front.
• Fit the two hood support brackets (fi g.2) using
the screws 12a (3.5 x 16) at a distance B of min.
85mm - max. 165mm. The brackets must be fi tted
differently according to the size of the hood to be
mounted.
• Remove the Comfort Panel (see the paragraph on
Maintenance).
• Remove the metal grease fi lters one at a time, re-
leasing the fasteners provided (see the paragraph
on Maintenance).
• Remove the profi le after unfastening the 4 screws
that fi x it to the Hood (fi g.4).
• Remove any Activated Charcoal Filters (see the
paragraph on Maintenance).
• Insert the Hood until it connects with the snap-on
side Supports. (fi g.3)
• Lock it in position by tightening screws Vf from
underneath the Hood. (fi g.3)
• It is now possible to fasten the hood to the wall-
mounted unit using the screws 12a (3.5 x 16)
provided. (fi g.4).
• Replace the profi le, using the 4 screws removed
as above.
• Replace the fi lters.
• Replace the Comfort Panel.
273
2
3
Vf
12a
EN
1
B
4