Cleaning And Maintenance; Technical Specifications - HQ Power VDLP36CW Notice D'emploi

c) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the device is attached should be able to support 10 times the weight of the device for
one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable (VDLSC7 or VDLSC8).
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack. Install a switch with an
opening of at least 3mm between contacts if the device is directly connected with the mains.
• The installation has to be approved by an expert before the device is taken into service.

5. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location should not be deformed, modified or
tampered.
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp.
8. Contact your dealer for spare parts if necessary.

6. Technical Specifications

Power Supply
Power Consumption
Dimensions
Total Weight
Lamp
Max. Ambient Temperature
Max. Housing Temperature
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
VDLP36CW_v2
230VAC/50Hz
max. 30W
Ø120 x 160mm
1.3kg
LAMP36, LAMP36B, LAMP36G, LAMP36R, LAMP36Y
45°C
90°C
5
VELLEMAN