Onkyo DAC-HA300 Mode D'emploi page 9

L M
USB cable for computer
connection
(USB micro-B connector to
USB A connector)
N
USB cable included with
iPod/iPhone/iPad device
L
Computer connection port
Use the included USB cable for computer connection (USB micro-B
connector to USB A connector) to connect this unit to a computer.
o To use a Windows computer for playback, you must install the
dedicated driver on the computer beforehand.
M
Force shutdown switch
Turn the power/volume knob to the OFF position, and then insert a
fine pin such as the end of a paper clip into this hole.
The unit turns off.
N
iPod/iPhone/iPad device connection port
Use the USB cable included with the iPod/iPhone/iPad device to
connect it to this unit.
o Connecting anything other than an iPod/iPhone/iPad to this port
could cause the operation time of the battery to be significantly
reduced.
Precaution during operation
While a pop-up message such as "Processing... " "Loading... " or "Removing... "
appears on the display, do not connect anything to or disconnect anything from
the computer connection port or iPod/iPhone/iPad device connection port.
Note about input sources
This unit does not have an input selection switch. When this unit is turned
on, the first device connected to it becomes the input source.
If multiple devices are already connected to this unit when it is turned on,
the input source will be selected with the following priority: computer con-
nection port, iPod/iPhone/iPad device connection port, digital audio input/
output and analog audio input jack, microSD card slot.
To change the input source, turn the unit off once and connect the
desired device.
EN
9