Output Power - Sunforce PRO Série Notice D'utilisation

• To avoid battery drain, always disconnect the inverter when not in use.
• Do not expose the Pure Sine Wave Inverter to rain, snow, spray or bilge water. To
reduce risk of a fire hazard do not cover or obstruct the ventilation openings. Do not install the
inverter in a zero clearance compartment. Overheating may result.
• Avoid placing the inverter near sources of heat or in direct sunlight.
• Use only attachments recommended by the manufacturer. Doing otherwise may result in a risk of
fire, electric shock or injury to persons.
• To avoid a risk of fire and electric shock, make sure that existing wiring is in good condition and
that it is not undersized. Do not operate the inverter with damaged or substandard wiring. Do
not operate the inverter if it has been dropped or damaged in any way.
• Do not disassemble the inverter, not only will you void the warranty, but you may risk personal
injury from electrical shock or fire. Internal capacitors remain charged after all power is
disconnected.
• To reduce risk of injury, disconnect both AC and DC power from the inverter before attempting
any maintenance or cleaning. Turning off controls will not reduce this risk.
• Do not over tighten the nut on the DC input terminals. Damage to the DC input terminals
may result.
• Terminal posts at the rear get hot and burn skin, use caution when removing wires after a large
load has been applied
Specifications

OUTPUT POWER

Continuous
Surge power
BATTERY DC INPUT
12 V DC system
INVERTER AC OUTPUT
Voltage
Frequency
Wave form
Efficiency
PROTECTIONS
Reduced voltage starter
Low battery shutdown
DC Input overload voltage
Output overloads
Overload temperature
Short circuit shutdown
PHYSICAL
Ventilation
Weight
Dimensions
Problem
Low or No Output Voltage
Red LED Indicator On
650 W
1200 W
12 V DC nominal (11-15 V) operative
110 VRMS AC +/-10%
60 Hz +/- 2 Hz
Pure Regulation Pure Sine Wave
90%
Yes
Yes
Yes
yes
Yes
Yes
High Speed Cooling Fan
8.22 lbs. / 3.73 kg (4.4 kg)
12.99 x 9.06 x 3.54" / (33 x 23 x 9 cm)
Trouble Shooting
Reason
Poor contact with battery terminals
Poor battery condition
Incorrectly testing output voltage
Battery voltage below 10 V
Equipment being run has a higher
draw than inverter is capable
Solution
Check connections between inverter and
power source,
tighten or repair as needed.
Recharge or replace power source as
needed
Recharge or replace power source as
needed
Reduce load on the inverter or use a higher
capacity inverter