Table des Matières
Publicité
• The control box is not waterproof. It must be installed inside the vehicle.
• Find a suitable control box location. Confirm that the sensor wire length is sufficient to reach from the bumper to the control box location
before proceeding.
• Route the sensor wires into the vehicle to the control box.
Fig 1:
• Using the 19 mm (6/8 in.) hole saw (supplied), drill a hole in each of the 4 positions you marked in SENSOR INSTALLATION 1.
Fig 2:
• Insert the sensors into the holes one by one.
• Make sure the arrow direction points upward when inserting the sensor into the hole.
• To ensure a proper fit, make sure the sensor is seated firmly into the bumper.
Profile of the bumper
CAUTION
Do not paint the sensors. Paint could impair or disable the sensor function.
73
Publicité
Table des Matières
