Ryobi P737D Manuel D'utilisation page 7

APPLICATIONS
You may use this inflator for the purpose listed below:
 Inflating items such as motorcycle, car, and bicycle tires
NOTE: The inflator is not designed for commercial
applications.
WARNING:
Battery tools are always in operating condition. Always
remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
TO INSTALL/REMOVE BATTERY PACK
See Figure 1, page 9.
To install:
 Place the battery pack in the tool. Align the raised rib on
the battery pack with groove in the battery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
AIR HOSE AND ACCESSORY STORAGE
See Figures 2 - 3, page 9.
When the inflator is not in use, press the hose into the storage
area on top of the tool.
The inflator can be hung on a pegboard by the holes on top
of the tool housing.
When not in use, adaptors and needles provided with the
inflator can be placed in the storage area on the base of
the tool.
DIGITAL GAUGE
See Figure 4, page 10.
The digital gauge on the inflator serves as a pressure gauge
and monitors the amount of pressure being applied to the
item being inflated.
To turn the digital gauge on, install the battery pack and
squeeze the switch trigger.
NOTE: The digital gauge will automatically shut off when
not in use for 30 seconds.
OPERATION
USING THE INFLATOR
See Figures 5 - 6, page 10.
 Install the battery pack.
 Position air chuck clamp in the unlock position
perpendicular to the air hose.
 Place the air chuck on the valve stem.
 Push the air chuck down so that the threaded section of
the valve stem is inside the air chuck.
 Clamp the end of the air chuck down onto the valve
stem by pressing air chuck clamp down until it stops or
is parallel with the air hose.
WARNING:
Improperly attached hoses or accessories can become
detached under pressure and cause serious injury.
Possible air leaks can cause faulty pressure readings.
Make sure all connections are tightly secured.
 Squeeze the switch trigger and a readout will appear on
the gauge.
NOTE: The pressure readout on the gauge while inflating
is a measurement of the fluctuating pressure between the
item and the air hose. To get an accurate reading, release
the switch trigger and wait for the readout to adjust.
 The gauge will indicate the pressure in PSI. When the
desired pressure is reached, release the switch trigger
and disconnect the inflator.
NOTE: Maximum PSI for this unit is 150 PSI.
NOTICE:
Always leave the hose free of obstructions when the
tool is not in use. Overheating could occur if the hose
is blocked.
ACCESSORIES
See Figures 7 - 9, page 10.
The supplied accessories perform a variety of functions.
The tapered adaptor can be used on smaller pinch valves
to inflate small items like floats and children's toys, which
usually require the user to inflate them by blowing air into
them. The sport ball needle can be used to inflate any type
of sports ball or any other item that requires an inflation
sport ball needle.
NOTE: When inflating items of 10 PSI or less, inflate in short
bursts and check after each burst by feel or with a calibrated
measuring device to determine accurate pressure.
7 — English