Other Features - Uberhaus 87795024 Guide De L'utilisateur

Display
8
Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting,
then shows the actual (
RH (Relative Humidity) to 90% RH (Relative Humidity).
Error Codes and Protection Codes
AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for service.
ES- Temperature sensor error-- U nplug t he u nit a nd p lug i t b ack i n.If e rror r epeats,ca ll fo r se rvice.
P1- Unit is defrosting-- Allow the unit time to automatically defrost. The error will clear after the
unit self -defrosts.
P2- Bucket is full or bucket is not in correct position-- Empty the bucket and replace it in the right
position.
E1- Unit malfunction-- Unplug the unit and plug it back in. If error repeats, call for service.

Other features

Bucket Full Light
Glows when the bucket is ready to be
emptied, or when the bucket is removed
or not replaced in the proper position.
Auto Shut Off
The dehumidifier shuts off after 30 seconds when
the bucket is full, or when the bucket is removed
or not replaced in the proper position. When the
setting humidity is reached, the unit will be shut
off automatically. For some models, the fan motor
will continue operating
Auto Defrost
When frost builds up on the evaporator coils, the
compressor will cycle off and the fan will continue
to run until the frost disappears.
Wait 3 minutes before resuming operation
After the unit has stopped, it cannot restart its
operation in the first 3 minutes. This feature protects
the unit. Operation will automatically start after
3 minutes.
Check filter feature
The system starts to count the time once the fan
motor operates. The check filter feature can be
only activated when the accumulated operation
time achieves 250 hours or more. The Reset light
(Clean filter indicator light) flashes at one time per
second, after finishing clean the air filter, press the
Filter pad and the Reset light (Clean filter indicator light)
goes off.
Auto-Restart (on some models)
If the unit stops unexpectedly due to the power
cut, it will restart automatically with its previous settings
when the power resumes.
CONTROL PADS ON THE DEHUMIDIFIER
± 5% accuracy) room % humidity level in a range of 30%
Setting the Timer
When the unit is on, first press the Timer
button, the Timer Off indicator light
illuminates. It indicates the Auto Stop
program is initiated. Press Timer button again-the
Time On indicator light illuminates.It
indicates the Auto Start is initiated.
When the unit is off, first press the Timer
button, the TIMER ON indicator light
illuminates. It indicates the Auto Start
program is initiated. Press the button again-the
Time Off indicator light illuminates.It
indicates the Auto Stop is initiated.
Press or hold the UP or DOWN pad to
change the Auto time in 0.5 hour incre-
ments, up to 10 hours, then in 1 hour
increments up to 24 hours. The control
will count down the time remaining until
start.
The selected time will register in 5 seconds
and the system will automatically revert
back to display the previous humidity
setting.
When the Auto start & Auto stop times are
set, within the same program sequence,
TIMER ON/OFF indicator lights illuminate
identifying both ON and OFF times are
now programmed.
Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel
the Auto Start/Stop function.
When LED display window displays P2 code,
the Auto Start/Stop function will also be
cancelled.
5