Additional Safety And Working Instructions - Güde BSS 18 1/4" Mode D'emploi

ENGLISH
12
Symbols
WARNING / CAUTION!
WARNING - Read the operating instruc-
tions to reduce the risk of injury.
Wear eye protective goggles !
Wear ear protectors!
Take the replaceable battery from the
appliance before any extension, cleaning
and servicing works.
CE marking
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
Battery
Protect the battery against heat and fire.
Protect the battery against water and
moisture.
Protect the battery against temperatures
above 40°C.
Do not throw the batteries in household
waste.
Li-Ion
Deliver the batteries to a collection centre of
old batteries where they will be recycled in
an environmentally friendly way.
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
Safety information for impact
wrenches
Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting
a „live" wire may make exposed metal parts of the
power tool „live" and could give the operator an
electric shock.
Additional Safety and Working
Instructions
Wear ear protectors. Exposure to noise can cause
hearing loss.
Use protective equipment. Always wear safety
glasses when working with the machine. The use of
protective clothing is recommended, such as dust
mask, protective gloves, sturdy non-slip footwear
and ear defenders.
The dust produced when using this tool may be
harmful to health. Do not inhale the dust. Use a dust
absorption system and wear a suitable dust protec-
tion mask. Remove deposited dust thoroughly, e.g.
with a vacuum cleaner.
Clamp your workpiece with a clamping device.
Unclamped workpieces can cause severe injury and
damage.
Check all screw and plug-in connections and
protective equipment if firm and tightened
properly and whether all moving parts are
running smooth whenever the appliance is to be
put into operation.
The appliance must not be used if damaged
or safety equipment is defective. Replace any
worn-out and damaged parts.
Do not use the device near flammable liquids or
gases. Risk of fire and explosion in case of short
circuit.
Please turn the device immediately off when the
tool used gets blocked! Do not turn the device on
again when the tool is still blocked. This could cause
bounce back with a high reaction moment. Deter-
mine and remove the cause of the blocking of the
tool used while respecting the safety instructions.
The possible causes may be:
• it is tilted in the workpiece to be machined
• it has pierced through the material to be machined
• the power tool is overloaded