Don't use the machine outside or in an area with high humidity!
The maintenance/use of the machine is forbidden if you are tired, concentrated
as well if you are under the influence of medicaments, alcohol and other drugs.
BEWARE: Routine leads to insufficient attention.
Do not install collector tubes or electric cables across the floor.
Do not operate the dust collector without filter bag or dust collector bag!
The electric connection of the machine to the power supply must be carried out
by a trained electrician.
The power supply must be grounded and has to have a short-circuit protection.
The power socket must be grounded and suitable for 16A.
For further details consult section 4.2 of this manual.
Disconnect the machine from the power supply prior to performing maintenance
or other activities.
Never use the power cord to transport the machine or pull it around.
If an extension cord is required, it has to have a sufficient cross-section, but at
least 1,5mm².
Control periodically the condition of power plug, power socket power cords.
Replace immediately if damaged.
Do not insert any objections into the dust collector hood and keep hand away
from the dust collector hood when machine is connected to power supply.
Regularly check the dust collector hood for debris and clean it if necessary.
Do not dismount the protective fence in the dust collector hood. It is a security
component and must be left in place.
10.2
Remaining risk factors
Despite of correct and proper use and maintenance there remain some residual risk factors:
Hazard of injury or machine damage due to undetected machine defect
To minimize this risk, check the machine prior to every operation for loose screws and
connections. Check the motor noise, the collector tubes, filter bag, dust collector bag and
impeller for eventual damage. Damaged parts have to be replaced immediately, no
operation of the machine in the meantime!
Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric
installation, and let it check periodically by a trained electrician.
Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or
activities on the machine.
Hazard of inhaling toxic wood dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are
harmful when inhaled. Therefore let the dust settle for 10 Minutes before you change the
dust collector bag and wear a suitable breathing mask if required.
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Absauganlage / Dust collector ABS 3000/4000/5000
SAFETY
Seite 19