Euroflex Standard Mode D'emploi page 13

English
length of the wristband can be adjusted with the press stud. Overhanging tape can easily
be shortened to the ideal length of 25 mm.
Turning the gloves equipped with plastic wristband:
1. Turn the glove from the inside out to the left.
2. Unscrew the press stud, or, in the case of cuffed gloves, the press studs.
3. Change the tape in the tape channel. For the cuffed gloves, guide the wrist band subse-
quently through the loop in the wristband channel to the outside.
4. Re-attach the press studs with the press studs lying outside.
Putting on the Arm Protection Gloves
1. Hook the wristband into the two rear fasteners so that the wristband is lying flat on the
skin.
2. Put on the arm protection glove and pull it up to the shoulder.
3 Next, lead the straps under the armpit around the body to the front fastener and hook it
in, also.
Arm protection glove front
The length of the strap must be adjusted so that the glove has a good grip but still enough
freedom of movement remains for unimpeded working.
Maintenance and Cleaning
UROFL X
®
safety gloves are made of a stainless steel ring fabric, whereby each ring is
individually welded. Even with a loss of a few individual rings, the glove must be repaired to
ensure safety. The repair may only be carried out by specialised companies which can resto-
re the original condition. Please use our RENOFLEX service, which guarantees quality resto-
ration. Continuous loss of rings in several places indicates that the ring braid is largely wea-
kened (due to wear, fatigue, and the likes). The glove must then be withdrawn from use. For
safety reasons, a specialist company should decide whether the repair is still economically
viable and can be advocated.
Arm protection glove rear
13