Technical Data; Before Starting The Equipment; Attachment And Operation - elem Garden Technic BV2502W Traduction Des Instructions D'origine

Technical data

Mains voltage V
Mains frequency Hz
Power input W
-1
No load speed min
Branch diameter, max. mm
Protection class
Weight kg
Information concerning
measured
according to relevant standards:
Sound pressure L = 95,7 dB(A)
PA
Guaranteed sound power L
Uncertainty Kpa = 3 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according to
relevant standard. : < 2.5 m/s²
The declared vibration total value has been
measured in accordance with a standard test method and
may be used for comparing one tool with another that the
declared vibration total value may also be used in a
preliminary assessment of exposure.
A warning that the vibration emission during
actual use of the power tool can differ from the declared
total value depending on the ways in which the tool is
used and of the need to identify safety measures to
protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account
230-240
50
2500 S6(40%)
4050
40
IP24
14,1
noise emission
= 111 dB(A)
WA
ATTENTION !
must be worn.
of all parts of the operating cycle such as the times when
the tool is switched off and when it is running idle in
addition to the trigger time).

Before starting the equipment

Warning! You may need assistance when lifting
the machine out of the box and assembling.
Open the package and remove the machine from
package;Pull out the collect box and take out the main
part of the machine and all accessories;
Assembly of the shredder (Fig. 4)
• Turn the shredder upside down.
• Pivot the legs upward, place the supplied wheel axle
through the respective openings.
• Attach pods to guide the wheels
• Mount wheels on both sides and secure with washer
/ nut
• Attach hubcaps
Warning! Take care when tilting the unit onto
its wheels as the unit has an uneven weight dis-
tribution when tilted and during wheeled trans-
portation.
Collect box (Fig. 3)
Push the collect box into the undercarriage after
pushing the lock button (6) upward.

Attachment and operation

• Before starting the machine, look into the feeding
chamber to make certain, that it is empty
• Keep your face and body away from the feed intake
opening
• Do not allow hands or any other part of the body or
clothing inside the feeding chamber,discharge chute,
or near any moving part
• Keep proper balance and footing at all times. Do not
overreach. Never stand at a higher level than the
base of the machine, when feeding material into it
• Always stand clear of the discharge zone when
5