Table des Matières
Publicité
WARNINGS
The information in this manual is subject to change without advance notice.
The manufacturer shall not be held liable for any errors which this document may contain.
ATTENTION
• After removing the packaging, check the condition of the unit.
• The packaging items (plastic bags, expanded polystyrene, etc.) must not be handled by children as they may be dangerous.
• Carefully read the instructions before starting installation. Perform work as specified by the manufacturer.
• Before connecting the equipment, make sure that the rating plate data corresponds to that of the distribution network.
• An omnipolar switch, with contacts separated by at least 3mm, must be installed upstream on the equipment, on the electric system of
the building.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
• Before performing any cleaning or maintenance operation, disconnect the equipment from the power supply network by opening the
system switch.
• In case of failure and/or malfunction of the device, detach it from the power supply and do not tamper with it.
• Use original spare parts.
• Installation, programming, commissioning and maintenance of the product must only be performed by qualified technicians who have
been properly trained in compliance with current standards including compliance with accident prevention.
• Operate in sufficiently lighted areas that are conducive to health and use tools, utensils and equipment that are in good working order.
• Upon completion of installation, always check for correct operation of the unit and the system as a whole.
• Do not install the device outdoors or in areas where it is exposed to seepage or splashes of water.
• Handle the device with care. It contains electronic parts that are fragile and sensitive to humidity.
• The electronic cards can be seriously damaged by discharges of static electricity. If they are to be handled, wear suitable clothing and
anti-static footwear, or at least, ensure static electricity has been discharged by touching with the fingertip a metallic surface connected
to the earth system (e.g. the chassis of a household appliance).
• Weld the joints between wires to prevent false alarms caused by oxidation of the wires.
• The electrical system must comply with current standards in the country of installation.
• Failure to comply with the above instructions may compromise the unit's safety.
• The installer must make sure that the information for the user, where applicable, is present on the devices.
• Dispose of the unit in accordance with current standards.
3
NAXOS
IT
EN
Publicité
Table des Matières
