Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2. Fold the retainer bracket ⑧ upwards, until it engages, and draw the document holder ② out.
3. Insert the plug into a mains power socket.
4. Switch the appliance on by pressing the ON / OFF, switch ④. The red control lamp ⑦ glows.
As soon as the green control lamp ⑥, glows the appliance has reached its operating temperature.
Additionally, an acoustic signal sounds.
5. Select a suitable thermal binder cover for your document:
6. Tap the sides of the sheaf of papers a few times to ensure that ALL of the sheets are lying exactly above
each other.
7. Lay the sheets into a suitable thermal binder cover and then tap them down a couple of times, against and
using the cover spine.
8. Slide the thermal binder brochure through the retainer bracket ⑧ into the binding shaft ① such that the
spine of the brochure makes firm contact with the hotplate on the floor of the thermal binder shaft ①.
9. Press the START ⑤button. The Red control lamp ⑦ glows, the Green control lamp ⑥ blinks.
10. As soon as an acoustic signal sounds and the Green control lamp ⑥ glows constantly you can remove
the thermally bound brochure from the binding shaft ①. Place it in the document holder ② so that the
adhesive can harden. The binding is sufficiently hardened after approx. 60 seconds.
11. After use, place the ON/OFF switch ④ at 'O' and remove the plug from the mains power socket.
Note:
If you are binding particularly thick documents, from a spine width of 20 mm and up (200 sheets and more),
then repeat the binding process approx. 5 times.

Safety instructions

Injury hazard
● This appliance is not intended for use by individuals(including children) with restricted physical,
physiological or intellectual abilities or deficiencies in experience and/or knowledge unless they are
supervised by a person responsible for their safety or receive from this person instruction in how the
appliance is to be used.
● Children should be supervised to ensure that they do not play with the appliance.
● Unplug the power cable after every use and before cleaning, so as to prevent the appliance from
switching itself on inadvertently.
● Check the appliance and all parts for visible damages. The safety concept can work only if the appliance
is in a faultless condition.
● Ensure that the appliance stands at a safe and secure positioning.
● Do not operate the appliance if it has sustained a fall or is damaged. Arrange for the appliance to be
checked and, if necessary, repaired by qualified technicians.

Publicité

Table des Matières
loading

Table des Matières