Memory Function - Senville SENCH-22 Manuel D'utilisation

SETTING THE TIMER TO TURN ON
THE HEATER
When the heater is in stand-by mode,
press the timer button to automatically
turn on the heater in a specific number
of hours set in a sequence from 0
hours. Press the UP button to increase
1 hour each time, and DOWN button
to decrease 1 hour each time.
SETTING THE SWING
The heater will swing internally by
pressing the swing button once.
To stop the swing, press the button
again. This button only works when the
heater is in HIGH or LOW mode.

MEMORY FUNCTION

it will resume operation in the mode it
is unplugged then plugged back in again,
it will default to the original settings:
HIGH mode and a temperature setting
of 95 ° F.
SETTING THE AUTOMATIC DISPLAY-OFF
FUNCTION
When the unit is working and no button is
automatically. Only the heating symbol is
24
function, press the UP and DOWN buttons
at the same time for 2 seconds. To allow
resume, again press the UP and DOWN
buttons for 2 seconds.
TEMPERATURE SENSOR SHORT
CIRCUIT PROTECTION
When the temperature sensor triggers
the short circuit protection, the display
screen will show E1 or E2 and flash.
None of the buttons will work, and the
buzzer rings 10 times. When this
occurs, please contact a qualified
electrician.