Maintenance Schedule; Daily Maintenance - Metabo HPT CS 33EDTP Mode D'emploi

English
4) Round off front corner to maintain original shape of
depth gauge after using depth gauge tool. Always
follow the recommended depth gauge setting found
in the maintenance or operator manual for your saw.
(Fig. 44)
NOTE
Do not fi le or alter the tops of bumper tie strap (55)
or bumper drive link (56).
Otherwise, this could increase the tendency of the
chain saw to kick back. (Fig. 45)
55
GENERAL INSTRUCTIONS FOR
FILING CUTTERS
File (57) cutter on one side of the chain from the inside
out. File on forward stroke only. (Fig. 46)
57
5) Keep all cutters the same length. (Fig. 47)
18
Fig. 44
91VG
56
91PX
Fig. 45
57
57
Fig. 46
Fig. 47
6) File enough to remove any damage to cutting edges
(side plate (58) and top plate (59)) of cutter. (Fig. 48)
58
S H A R P E N I N G A N G L E S F O R
SHARPENING SAW CHAIN
1. Part Number
2. Pitch
3. Depth Gauge Setting
0.025"
4. Side Plate Filing Angle
80°
5. Top Plate Angle
30°
6. File Guide Angle
Replacement bar and chain combination
BAR NO. LENGTH-
(E&S) TYPE
PO12-50CR 12" SPROCKET
PO14-50CR 14" SPROCKET

Maintenance schedule

Below you will find some general maintenance
instructions. For further information please contact
metabo HPT Authorized Service Centers.
Inspection and service before use
○ Check that no peel-off , degradation, or damage is
observed in the Anti-Vibration rubber members, and
no loosening or damage is observed in their fi xtures.
○ Check that no damage is observed in the Anti-
Vibration springs, and no loosening or damage is
observed in their fi xtures.
○ Check that no deformation or damage is observed
in the front and rear handles.
○ Check that the fi xtures for front and rear handles are
suffi ciently tightened and free of damage.
○ Check that bolts, nuts, etc. used for each part are
suffi ciently tightened and free of damage.

Daily maintenance

○ Clean the exterior of the unit.
○ Clean the chain oil fi lter port.
○ Clean the groove and oil fi lter port in the guide bar.
59
Fig. 48
91PX / VG
3/8"
0.025"
80°
30°
90°
NOSE- CHAIN NO.
TYPE (OREGON)
91PX045
91VG045
91PX052
91VG052
CKA
44°
50°
45°
35°