Connections Sheamtic - sauter STE 604 XF1 Manuel D'installation

C60T051A3 02•1•10 11:26
The hot plate is supplied with a power cable.
If the power feed wire is damaged, it must by replaced by the manufacturer,
by the after-sales service or by authorized personnel for safety reasons.
If the type of connections to which the hotplate is to be installed is other than
220 to 240 V Ac rmove the cable and make the connection according to the
adjacent drawings. (The cable must support temperatures of up to 120ºC).
The hotplate must be connected to the mains with a plug that meets the EEC
7 publication or with a multi-pole with a distance between the open contacts
of a least 3 mm.
Total power
Hotplate: 60 cms., 6,3kW
PLATE
60 cms
PLATE
60 cms
This device conforms to European directives 73/23/Cee and 89/336/CEE
Página 33
CONNECTIONS SCHEAMTIC
Voltage Int.nominal Protection
by phases
220...240V~ 27,5 A
Three phase ∆
Voltage Int.nominal Protection
by phases
380...400V~ 11 A
Three phase ∆
Tensión Int.nominal
por fases
32 A 220...240V~ 14 A
Voltage Int.nominal
by phases
12 A 380...400V~ 16 A
31
Protección
16 A
Protection
20 A