Cleaning And Maintenance; Safety Instructions; Daily Maintenance - Casselin CMIX160 Mode D'emploi

6. CLEANING AND MAINTENANCE

6.1 Safety instructions

Caution: When cleaning the mixer stand with its knife, be careful of the risk of cuts.
NEVER clean the appliance with a water jet.
NEVER immerse the engine block in liquid.

6.2 Daily maintenance

Unplug the unit
The unit can be cleaned with a slightly damp sponge or cloth.
To clean the inside of the bell, operate the unit with the dive tube and bell in clear water for 3 seconds.
Clean the foot with clear water, if necessary with a washing-up liquid.
Store the unit in a dry place.
6.3 Safety instructions for the maintenance of the device
Daily check for damage to the power cord. Never use the camera when the power cord is damaged. If the
power cord is damaged, it must be replaced by a qualified service technician.
In the event of a malfunction, contact your dealer.
Any maintenance or repair work should only be carried out by a professional.
NOTE
If disconnected, unplug the unit, allow it to cool down and contact your dealer. If the unit does not start, check
your power cord. The unit should not be plugged into a multi-outlet but directly into a wall outlet. For any other
abnormality, contact your dealer.
NOTE
Waste from used equipment: When disposing of used equipment, please comply with the regulations in force
in your country*. Before disposal, the device must be rendered unusable by removing the power supply cable.
* in terms of ecology and recycling
EN