Transport, Packaging And Storage; Inspection Following Transport; Packaging; Storage - Casselin CMIX160 Mode D'emploi

3. TRANSPORT, PACKAGING AND STORAGE

3.1 Inspection following transport

The check for damage and completeness must be carried out upon receipt of the package. If transport
damage is identified, refuse or accept the delivered product only with reservation*. A complaint detailing the
defects found must then be made. Damage can only be detected if the complaint is made within the specified
time limit, i.e. 24-48 hours maximum
*written on the carrier's paper or digital delivery notes.

3.2 Packaging

The packaging of the appliance must be kept in case of moving or for return to the after-sales service. The
inner and outer packaging must be completely removed before using the unit. The environmental protection
regulations applicable in your country must be observed before the packaging is disposed of.

3.3. Storage

ATTENTION
The unit can only be stored in its original, closed packaging.
Storage can be carried out under these conditions :
• Storage in a dry and non-humid place
• Sheltered from the sun
• Stock control over 2 months (general condition of the device and all its components)
• No shaking of the equipment
• Storage in a closed room and not outside.
4. HARDWARE CHARACTERISTICS
* Subject to change without notice
Model
Electrical data
Speed
Total length
Tube length
Diameter
Net weight
Noise level
CMIX160
220 W / 220 V - 240 V
3000 – 13 000 Tr/min
395 mm
160 mm
70 mm
0.990 Kg
60 dB
CMIX190
250 W / 220 V - 240 V
3000 – 13 000 Tr/min
425 mm
190 mm
70 mm
1.2 Kg
60 dB
EN