Sigmar marine B0 20 Manuel De L'utilisateur page 15

POS. DESCRIPTION
1 Red plastic washer
2 Yellow plastic washer
3 Blue plastic washer
4 Relief/non return valve
5 Element gasket
6A Electric element
800W 220V
6B Electric element
800W 110V
6C Electric element
1200W 220V
6D Electric element
1200W 110V
7 Bi-Thermostat
8 Power supply cable
9 Nut M4 Stainless steel
10 Boiler resistor cover
11 Self-tapping screw 3,5 x 13
stainless steel
BOILER COMPACT 20/80 - REV001B
CODE
PVRPC300R000
PVRPM300G000
PVRPF300B000
MNVALS120000
• shut down power supply.
PGR031430000
• Remove the protection cover (10) in order to reach
EVR08220NSG0
the thermostat (7).
• Push the reset button on the double thermostat
EVR08110NSG0
(fig. 6).
• Replace on the protection cover (10).
EVR12220NSG0
• Switch on power supply.
EVR12110NSG0
EVT101100000
EPSSCH315015
MBD04MXEN000
PCCBRNP00000
MAINTENANCE
MBV03513AXSC
F
The overpressure release device must be activated regu-
larly to remove calcium deposits and to ensure that it is
not blocked.
Periodically check the joints of the water pipe instal-
lation; check the tightness of the securing screws and
replace them in case they are worn or corroded.
Also periodically check the electrical system working
order.
MAINTENANCE
WARNING: Sigmar Marine nautic water heaters
are provided with a double thermostat with
manual reset that shuts down power supply in
case of an excessive water temperature.
If it happens, follow the instructions below:
WARNING: if the high temperature safety system
switches on repeatedly, call Sigmar Marine service
center.
During wintertime, when the water heater is not
in use it should be drained using the lever of the
valve (4). This is to avoid serious damage caused
by freezing.
GB
15