Functional Description; Intended Use; Product Features - Bosch GOF 2000 CE Professional Notice Originale

OBJ_BUCH-622-002.book Page 20 Wednesday, September 3, 2008 11:45 AM
20 | English
Do not use blunt or damaged router bits.
Blunt or damaged router bits cause in-
creased friction, can become jammed and
lead to imbalance.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for routing grooves,
edges, profiles and elongated holes as well as
for copy routing in wood, plastic and light build-
ing materials, while resting firmly on the work-
piece.
With reduced speed and with appropriate rout-
ing bits, non-ferrous alloys can also be ma-
chined.
1 609 929 N94 | (3.9.08)

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Adjustment knob for depth-of-cut fine ad-
justment
2 Scale for depth-of-cut fine adjustment
3 Right handle
4 Depth stop
5 Clamping lever for depth-of-cut coarse ad-
justment
6 Scale for coarse adjustment of depth-of-cut
7 Adjustment knob for coarse adjustment of
depth-of-cut
8 Step buffer
9 Spindle lock button
10 Wing bolt for guide rods of parallel guide
(2x)*
11 Tightening nut with collet
12 Guide plate
13 Dust boot
14 Base plate
15 Left handle
16 Release lever
17 Thumbwheel for speed preselection
18 Lock-on button for On/Off switch
19 On/Off switch
20 Lock for release lever
21 Open-end spanner, size 24 mm*
22 Router bit*
23 Extraction hose (Ø 35 mm)*
24 Extraction adapter*
25 Wing bolt for extraction adapter (2x)*
26 Parallel guide*
27 Guide rod for parallel guide (2x)*
28 Wing bolt for fine adjustment of parallel
guide (2x)*
29 Wing bolt for coarse adjustment of
parallel guide (2x)*
30 Fine-adjustment knob for parallel guide*
31 Edge guide for parallel guide*
32 Extraction adapter for parallel guide
Bosch Power Tools