Carat DPZ230NK00 Manuel D'utilisation page 12

8. Tighten [e] Flange Bolt x 4pcs by [p] Hex
Wrench.
(Fig.10)
9. Remove [d] Centering Holder.
10. Set the proper Spacer [g] / [h] / [ i ] / [k] / [m]
on the spindle of the angle grinder.
11. Set [ f ] Base Flange on Spacer.
12. Set the Blade on [ f ] Base Flange and
tighten the Lock Nut by Wrench.
==> Pay attention to the Lock Nut direction.
(Fig. 11)
13. Push the Lever.
14. Close the Lower Base.
(Fig.12)
Lower Base
METABO BOSCH
[g]
T3.5
15. Confirm the Blade installed horizontally. (Fig.13 and 14)
O K
DEPTH ADJUSTMENT
1. Push the Lever.
2. Slide the Lower Base and hook the Lever
at the position of the proper Cutting Depth.
(Fig.15)
[CAUTION]
Use the Scale just for a reference as it should
be affected by the status of the Blade.
-12-
13
Lever
14
Fig.12
DEWALT
[h]
I.T4.5
Fig.13
[p]
[e]
12
Blade
11
[d]
HITACHI MILWAUKEE
[ i ]
T6.0
N G
1
2
Lower Base
Cutting Depth
8
Wrench
Lock Nut direction
10
9
MAKITA
[k]
T9.4
Scale (230mm Blade)
Scale (180mm Blade)
Fig.10
FLEX
Others
[ f ]
[g] [h] [i] [k] [m]
Fig.11
FLEX
[m]
T10.6
Fig.14
Fig.15