Shut down your notebook and disconnect the AC adapter.
2
Turn the system over so the bottom is facing up, oriented as in Figure 22.
3
Press the "unlock" latch to the right, then press and hold the "hold" latch to the left. Lift the rear of the battery up
4
as in Figure 23, then lift the battery out of the bay.
Insert a new battery into the bay, and press it down so that the latches click into place.
5
Plug in the AC adapter and turn the power on.
6
Hot-swapping Batteries
To hot-swap batteries in your battery bay follow these easy steps:
B
E SURE TO PLUG IN AN
THE BATTERY IS BEING REPLACED
Plug an AC Adapter into the system and connect it to a power outlet.
1
Follow steps 3 and 4 in "Cold Swapping Batteries".
2
I
L
F THE
ITHIUM ION BATTERY CONNECTOR IS NOT FULLY SEATED
AC A
DAPTER PRIOR TO REMOVING THE BATTERY
. I
AC A
F YOU DO NOT USE AN
46 - Lithium ion Battery
. T
HERE IS NO BRIDGE BATTERY PRESENT TO SUPPORT THE SYSTEM WHILE
DAPTER YOU WILL LOSE ANY UNSAVED FILES
,
YOU MAY NOT BE ABLE TO USE YOUR NOTEBOOK OR CHARGE YOUR BATTERY
.
.