HQ CAR-CMPR01 Mode D'emploi page 2

CAR COMPRESSOR 250 PSI
Specifications:
Power input: 12 V DC
Pressure: 250 PSI
Length: 3 metre power cord
Including connectors for multiple applications
Compressor Operation:
1. Ensure the vehicles ignition is in the "off" position.
2. Connect the car cigarette plug of the compressor with the
vehicles cigarette power source.
3. For tyre inflation use the universal adapter that is attached
permanently to the air hose. Place this adapter (see picture)
onto the tyre valve system and press the adapter lever down to
lock on.
4. Check the pressure gauge and determine the required
pressure.
5. Turn on the ignition of your vehicle, so the cigarette source is
powered.
6. When the required pressure is reached, turn the ignition to the
"off" position again or pull the car plug from it's source to turn
the compressor off.
Note: to inflate leather balls, flotation devices etc. use one of the plastic nozzles.
Safety Precautions:
- When using the air inflator, be sure the car motor is not running.
- Do not use the compressor on high pressure tyres, such as used on trucks, trailers or tractors.
- Do not use the compressor continuously for more than 10 minutes. After each use it should be
cooled down for 8 minutes to extend the life of its motor.
- The compressor should be stored/used in dry areas.
Safety precautions:
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
ENGLISH
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
2