Publicité
Les langues disponibles
Les langues disponibles
Filter connection kit for Kirami platic hot tubs
Kit contents:
Lead-in 2½"outer thread x 1½"inner thread (M6 for inner
•
thread plug)
Lead-in plug M6 outer thread
•
Gaskets, 3mm and 8mm to the wall
•
Nut 2½" inner thread
•
o
o
5 pcs hose clamp
•
1 pcs 1 1/2"uk/38mm hose coupling 90 degrees
•
Pipe tape roll
•
Pipe 5m (in one piece, the colour may vary)
•
A short discharge plug and lock bolt for discharge.
•
3 pcs protection grid for inlets/outlets in the tub
•
3 pcs M6 bolts for grill installation
•
Additional hoses and other equipment as well as chemicals can be purchased from us.
Connecting to the Plastic tub (Cozy & Easy & Family & Tilty)
is long enough from the suction to the filter and back. Make sure to clean the
sticks etc. after drilling holes.
Updated 13.9.2017
The above will be installed to the barrel, in case
the filter is purchased at the same time with the
barrel.
Family-model might have these parts installed,
depending of the product range of the target
country
Installation of the Kirami grommet kit for a plastic barrel is
very simple, you need to drill a hole just for a single inlet. A
Ø79mm hole needs to be drilled into the plastic itself and a
>Ø114mm hole into the wood panel at the same level. The
hole in the upholstery needs to be bigger in order to tighten
the inlet and to have enough space to rotate the
components into position.
The top hole must be drilled at least 46cm upwards from
the lower end of the wall boards. This way the Lead-in
comes out enough for the hose connector to fit into its
place. You can choose where to drill
the hole on the side of the barrel
otherwise freely, but it would be good
to have it at the seam of the panels,
so that the boards will not break, the
sealing is done only on the plastic.
Please note, however, that your hose
Page 6 / 20
© Kirami Oy, Finland
Publicité
