Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank and then tighten
the 2 screws of fixations (Important,
make sure that the screws have the
same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
MSC-513
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose, using
the supplied spanner.
4.
The tool
have a difference of more than 0.4mm
compared to the clamping diameter of
collect.
Example: clamping Ø 9.5mm - shank Ø
9.1 mm minimum
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 09.09.2015
shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
MSC-513 1- Mode
d'emploi
Page : 2 de 4
Publicité
