Technical Data; Before Use; Tool Inspection - Hilti DX 460 Mode D'emploi

5. Technical data

DX 460 tool
Weight
Tool length
en
Nail length
Recommended maximum fastening rate
Cartridges
Power regulation
MX 72 magazine
Weight
Nail length
Magazine capacity
Right of technical changes reserved

6. Before use

aa
6.1

Tool inspection

● Ensure that there is no cartridge strip in the tool. If
there is a cartridge strip in the tool, remove it by hand
from the tool.
● Check all external parts of the tool for damage at reg-
ular intervals and check that all controls operate prop-
erly. Do not operate the tool when parts are damaged or
when the controls do not operate properly. If necessary,
have the tool repaired at a Hilti service centre.
● Check the buffer and piston for wear (see "8. Care
and maintenance").
6.2 Choosing the right fastener guide / piston / fas-
tener combination
Use of the wrong combination may present a risk of
injury. Damage to the tool may also result or fastening
quality may be negatively affected (see table on last page
of these instructions).
24
Printed: 08.07.2013 | Doc-Nr: PUB / 5069834 / 000 / 02
3.25 kg (7.16 lb),
3.51 kg (7.78 lb) with magazine
458 mm (18.03"),
475 mm (18.7") with magazine
")
Max. 72 mm (2 7 /
8
700 per hour
6.8/11 M (27 cal. short) green, yellow, red, black
4 cartridge power levels, regulation wheel with locking
function
0.653 kg (1.44 lb)
")
Max. 72 mm (2 7 /
8
Max. 13 nails
aa
6.3 Conversion from single-fastener tool to maga-
zine tool (changing the fastener guide)
1. Ensure that no cartridge strip or fastener is loaded in
the tool. Remove the cartridge strip by pulling it
upwards out of the tool and remove the fastener from
the fastener guide / magazine.
2. Press the release button on the side of the fastener
guide.
3. Unscrew the fastener guide.
4. Check the buffer and piston for wear (see "Care and
maintenance").
5. Push the piston into the tool as far as it will go.
6. Press the buffer onto the magazine until it snaps into
place.
7. Push the magazine firmly onto the piston return unit.
8. Screw the magazine onto the tool until it engages.