Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing batteries to the remote control
1. Remove the battery cover from the back of the remote control.
2. Insert and fix 2pcs of batteries (CR2032) into the battery compartment
with the (+) facing upward.
3. Put the battery cover on the remote control and close it.
Battery charging
This speaker has a rechargeable lead acid battery inside .Please connect the
power cord to AC port to charge it. It takes around 6-8 hours to fully charge
the speakers. Disconnect power cord as soon as battery is fully charged (the
light on the LED display will turn to green).
Note: Battery will be charging in On and Off modes. In accordance with low
power consumption directives, the battery will not charge in standby mode.
Disposal of batteries
Dispose of used batteries with regard to the recycling regulations in your area.
Do NOT short circuit batteries or throw them into water, the general rubbish or
in a fire. Weak batteries can leak and damage the remote control. Replace
them in good time!
- 26 -
Publicité
Table des Matières
