Unpacking The Appliance; Overview Of The Components / Scope Of Delivery; Picture A; Picture B: Symbols On The Control Panel - Proficook PC-FR 1177 H Mode D'emploi

• Do not repair the appliance by yourself. Always contact an au-
thorized technician. If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
CAUTION:
This appliance is not intended to be immersed in water during
cleaning. Please observe the instructions that we have included
for you in the chapter "Cleaning".

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging materials like foils, filling materi-
als, cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.
4. If there are missing parts or obvious damage, do not use
the appliance. Return it to your retailer immediately.
Overview of the Components /
Scope of Delivery

Picture A

1 Air inlet opening
2 Air outlet opening
3 Housing
4 Fat tank with internal basket
5 Handle of the basket
6 Cover for the underlying release button
7 Control panel
8 Display

Picture B: Symbols on the Control Panel

9 indicator lamp
10 indicator lamp
11 indicator lamp
12 indicator lamp
13 indicator lamp
14 °C button
15 indicator lamp
16 indicator lamp
17 button
18 button
19 button
20 Min button
21 button
22 button
23 indicator lamp
24 P indicator lamp
25 indicator lamp
42
PC-FR1177H_IM

Notes for Use

Location

• Set the appliance onto a non-slip, level, and heat-resist-
ant surface.
• Take care that the appliance and the mains cable never
are placed onto hot surfaces or near heat sources (e. g.
range, hob).

Electric Connection

Before inserting the power plug into the outlet, check that
the mains voltage to be used matches that of the appliance.
You can find the required information on the nameplate.

Connected Wattage

The total power consumption of this appliance can be up
to 1700 W. With this connected load a separate supply line
protected by a 16 A household circuit breaker is recom-
mended.
CAUTION: Overload!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.

Standby (Standby Mode)

NOTE:
The appliance is in standby, if the
When faced with the following situations, the appliance will
switch into standby:
• When the power plug is inserted.
• If no button is pressed for approx. 60 seconds.
• When the time has elapsed.
• When you press and hold the
3 seconds.
button lights red.
button for approx.
12.12.18