Hema 80.00.5004 Mode D'emploi page 20

PARTS DESCRIPTION
1. Lid of reservoir
2. Tray
3. Control Panel (see below)
4. Reservoir with water level indication
5. Jug
6. Filter reservoir
7. Lid of jug
8. Anti drip function
CONTROL PANEL
OPERATION
Before first-time use:

Before using this device for the first time please carefully rinse all detachable components with warm
water.

Fill the reservoir with cold water to the maximum water level indication.

Afterwards brew water twice without coffee powder.
To percolate coffee:
1. Fill the reservoir with cold water.
2. Open the lid of the reservoir and fill it to the desired water level indication. The maximum capacity is 1.5L
(approximate 12 cups).
3. Place a commercially available filter in the filter reservoir and use the measuring spoon to add the amount
of coffee powder appropriate to the amount of cups you want to brew. Close the lid of the reservoir.
4. Now place the jug on the tray of the appliance.
5. Plug the power cord into an appropriate outlet. The LCD will display "12:00" and the colon will flash.
6. Start brewing coffee by pressing the ON/OFF switch once. The "RUN" indicator light will illuminate then.
The lid of the jug needs to be closed in order to unlock the drip stop function.
7. If you leave the device switched on, the tray will keep the coffee warm after finishing brewing. The whole
working process will last 40 minutes. After 40 minutes the unit will be automatically shut off and stop
working. You can manually press the ON/OFF switch again to switch on the appliance.
Note: The appliance is designed with an Anti-drip function. You can temporaily remove the jug and pour out
coffee during brewing cycle without coffee dripping from the appliance within 30 seconds.
CAUTION! When pouring coffee from the jug, pour it slowly. Do not incline the jug suddenly in a large tilting
angle, in case the hot coffee flows out from the lid rim and hurt people. Do not put an empty jug back on the
hot warming tray.
- 19 -