Machining - Worktop - Base Cabinet - GUTMANN NIVEL 8000 ML Instructions De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50

8. MACHINING - WORKTOP - BASE CABINET

1. Remove the front or drawers.
2. Define and mark the positions for the cut-out on the kitchen worktop. Please pay
attention to minimum distances and minimum web width! These may vary depending
on the material and material properties!
(Under certain circumstances use auxiliary crossbar "Reinforcement").
3. Saw out the cut-out on the worktop.
Pay attention to straightness and freedom
from burrs ! For "flush installation", mill
out the recess.
4. Seal milled surfaces.
5. Make a cut-out in the base and plinth of the base unit.
Drawer depth should be selected at approx. 200mm below cabinet depth.
6. Make the cut-out for the technology drawer on the rear wall of the cabinet and finish
with Install approx. 170mm distance to the rear side.
EN
43

Publicité

Table des Matières
loading

Table des Matières