Miele 07869810 Notice De Montage page 32

Produktgruppe 512
32 von 32
Mark the height of the top mounting strip A (1936 mm above finished floor surface) on the left and right
above the wall cutout, Fig. 1.
Align the strip A centrally to the wall cutout and mark the hole positions on the wall.
Drill the marked holes (6 mm diameter).
Insert the provided dowels in the holes.
Screw strip A lightly to the wall.
Align side strips B and C with the ends of top strip A, ensure that they are vertical and mark the hole
positions on the wall, Fig. 1.
Drill the marked holes (6 mm diameter).
Insert the provided dowels in the holes.
Unscrew top strip A from the wall.
Wall seal preparation:
Lay the wall seal with the front surface (soiled side) downwards on a flat surface and fold the wall-side
bars outwards, Fig. 2, Pos. 1.
Degrease the mounting strips A, B and C.
Remove the adhesive strip protective foil from the wall-side bars and stick the mounting strips A, B and C
in place, Fig. 2, Pos. 2.
Wall seal installation:
Warning!
Maximum gap between the machine and the wall cutout is 60 mm; see Fig. 3.
Fold the mounting strips A, B and C with the wall seal inwards (Fig. 2, Pos. 3) and fasten them to the wall
with the 4.8 x 25 hex screws and washers, Fig. 3.
Warning!
To simplify the process, start with the top strip A.
Check the exact positioning of the machine, and adjust and level it if necessary.
Degrease the machine in the area where the wall seal is to be attached.
Remove the adhesive strip protective foil from the machine-side bars and stick the bars to the machine.
Warning!
Take care to ensure that the seal is loose and not under tension, Fig. 3.
Note
To ensure that measuring results are not affected, the bottom 180 mm of the wall seal is not attached to the
machine.
am
24.01.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 07822940