Pioneer PL-30-K Mode D'emploi page 6

01
3 Pinch the ribbon tape and catch the belt on the outer center of the roller.
3
1 Roller
2 Belt
3 Ribbon tape
4 Square hole
4 Remove the ribbon tape.
5 Turn turntable slowly five or six turns.
Check that the belt is properly caught at the center of the roller.
6 Set the turntable sheet.
! The turntable mat has a top and a bottom side. Put the mat on the turntable so the bottom, which has the
Pioneer logo, faces down.
1
2
4
7 Attach the headshell.
Insert the headshell with attached cartridge into the tone arm. Next, while keeping the headshell horizontal,
tighten the lock nut.
8 Attach the balance weight.
Attach the balance weight to the rear shaft of the tone arm.
9 Mount the dust cover.
Insert the hinges of the dust cover securely into their holders on the back of the turntable.
! Insert both hinges fully.
! When removing the dust cover, open the dust cover fully then pull out upward with holding the dust cover
near the hinge retainer sections.
10 Remove the twist tie for clamping the tone arm.
Once assembly is finished, remove the twist tie for clamping the tone arm.
6
Before you start
AC IN
PHONO LINE