Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Disassembling the display stand
Remove the screws (four locations on the
1
left and right sides) and take off the bracket.
Bracket
Screws
How to install
In order to ensure safety during installation, always be sure to work together with more than two persons.
1
Assemble the unit
Screws
Label
Display stand
2
Remove the rear cover.
Rear cover
Attach the leg base to the display stand using the hexagonal
bored bolts (M8 x 60) so that the rear label faces towards
the back casters as the figure.
Note: In order to ensure safe installation, always be sure
to alternately tighten each bolt two times or more
until they are firmly fixed in place.
Leg base
Back casters
Support caster
Do not take out the screws.
Loosen the
finger screws.
Washer
Plate spring washer
Hexagonal bored bolts
(M8 x 60)
13
En
13
Publicité
Table des Matières
