Arris Touchstone WR2100 Guide D'installation Rapide page 8

Step 8: Now you can select a suitable location for the WR2100
Wireless Repeater. It's preferable to place the device near the center of
your wireless coverage area. Check the LED color and make sure it's
not red. Next go to "Setting Up Your Client Devices".
Locate the WR2100 Wireless Repeater in another
place for better wireless reception and performance
if the signal strength is weak (the
Manual Configuration with a PC
Step 1: Locate the WR2100 Wireless Repeater near the Wireless
Access Point while doing the configuration.
Step 2: Prepare an Ethernet cable (not included). It should be long
enough to connect the WR2100 Wireless Repeater to your PC.
Step 3: Plug the WR2100 Wireless Repeater into the power outlet and
press the Power button to power it on.
Step 4: The LED stays on for a few seconds then starts blinking. Wait
for the Power LED to be static on again. The WR2100 Wireless
Repeater is now ready for use.
Step 5: Connect the Ethernet cable to the WR2100 Wireless Repeater
and the PC.
Step 6: Launch the browser and enter either the device IP address,
192.1.168.0.254, or
Step 7: You will then be prompted for a username and password. If
using the default values, enter admin for the username, and password
for the password.
Step 8: Choose the Wireless page and click the "Site Survey" button.
The WR2100 Wireless Repeater will start to search the existing
wireless networks.
http://www.mywifirepeater.net/
6
LED is red).
in the Address box.