Performing The Initial Power-On Settings; Tv Controls - Schaub Lorenz LT32-25645 Instructions D'utilisation

6

Performing the initial power-on settings

6.1-TV controls

6.1.1-Temporary on/off (STAND-BY)
When you press the red
STAND-BY button located
on the upper right hand side
of your remote control while
your television is switched on,
the sound and the picture will
go off. In the stand-by mode,
the power indicator of your
television will glow brighter. To switch
your television back on, either press any
numeric button or PR+/PR- buttons.
Caution! If you are not going to use
your television for a long time, unplug its
power cable from the socket.
6.1.2-Program selection
You may enter whichever
program number you would
like by pressing the numerical
buttons or PR+/PR- buttons on
your remote control. To select
the programs that are above
9, you can enter the desired
program number by using the
numerical buttons. For example,
to switch to the program
number 12, press respectively
the numeric buttons 1 and 2 on
your remote control. You can
perform the program selection also from
the Program Table. (See page 12)
PROGRAM TABLE
00
Channel 01
Channel 02
03
04
SKIP
MOVE
SELECT
05 10
06 11
07 12
13
08
14
09
NAME
DELETE
BACK
MENU
6.1.3-Temporary sound mute (MUTE)
To temporarily mute the sound of
your television, press the MUTE
button on your remote control.
In that case, MUTE symbol will
appear on the screen. When you
press the same button a second time,
the sound will be restored. If you press
the VOL+ button while in the Mute mode,
the sound level is increased and the Mute
function is aborted.
6.1.4-Returning to Selected Program
(SWAP)
Allows you to switch between
the current program you watch
and the last viewed program.
For example, if you change the channel
to Program 11 while you were watching
Program 1, press SWAP button to switch
back to Program 1. Press SWAP button
to switch back to Program 11 again. You
can also switch between the sources.
PR 01
6.1.5-Main Menu
Press the MENU button. The
Menu including all the setting
menus will appear on the
screen. Navigate through the
Menu titles with the up / down
movement buttons and press
the OK button to select the
desired menu. If you want to exit the
menu in any step, just press the EXIT
button. Press BACK or MENU buttons
to return to the previous Menu while you
are in a sub menu.
MAIN MENU
VOLUME
PICTURE
PROGRAM TABLE
SETUP
FEATURES
9 I
k
PR 11
PR 01
MENU
SELECT
EXIT