Warranty Conditions - Bellman & Symfon BE1281 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Warranty conditions

Bellman & Symfon guarantees this smoke alarm (excluding the battery) for 5 (five)
years from date of purchase against any defects that are due to faulty materials or
workmanship. This guarantee only applies to normal conditions of use and service,
and does not include damage resulting from accident, neglect, misuse, unauthorized
dismantling, or contamination howsoever caused. This guarantee excludes incidental
and consequential damage. Further the warranty does not cover Acts of God, such
as fire, flood, hurricanes and tornadoes. If this smoke alarm should become defective
within the guarantee period, it must be returned to Bellman & Symfon, with proof of
purchase, carefully packaged, with the problem clearly stated. We shall at our discretion
repair or replace the faulty unit.
Bellman & Symfon shall not be liable for any incidental or consequential damages caused
by the breach of any express or implied warranty. Any implied warranty of merchant-
ability or fitness for purposes is limited to the duration of the above warranty period.
This warranty gives you specific legal rights and you may also have other rights that vary
from state to state. Some states or jurisdictions do not allow the limitation or exclusion
of incidental or consequential damages, or limitations on how long an implied warranty
last so the above limitation may not apply to you.
Do not interfere with the smoke alarm or attempt to tamper with it. This will invalidate
the guarantee, but more importantly may expose the user to shock or fire hazards. This
guarantee is in addition to your statutory rights as a consumer.
Bellman & Symfon makes no warranty, expressed or implied, written or oral, including
that of merchantability or fitness for any particular purpose, with respect to the battery.
The above warranty may not be altered except in writing signed by both parties hereto.
27
FCC compliance statement
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
This device complies with Part 15 of the FCC
to try to correct the interference by one or more of the following measures:
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
• Reorient or relocate the receiving antenna.
harmful interference, and (2) this device must
• Increase the separation between the equipment and receiver.
accept any interference received, includ-
• Connect the equipment into an outlet on a circuit different from that to
ing interference that may cause undesired
which the receiver is connected.
operation.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID: WMSBETXSA2
Industry Canada statement
Warning: Changes or modifications to this
This device complies with Industry Canada licence-exempt RSS standard(s).
unit not expressly approved by the party
Operation is subject to the following two conditions:
responsible for compliance could void the
user's authority to operate the equipment.
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation
Note: This equipment has been tested and
of the device.
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
Le fonctionnement de cet équipement est soumis aux conditions suivantes:
FCC Rules. These limits are designed to pro-
(1) l'équipement concerné ne doit pas causer d'interférences, et (2) il doit
vide reasonable protection against harmful
accepter toute interférence reçue, y compris les interférences risquant d'en-
interference in a residential installation. This
gendrer un fonctionnement indésirable. Cet appareil numérique de la classe
equipment generates, uses and can radiate
B est conforme à la norme CNR-210 du Canada.
radio frequency energy and, if not installed
and used in accordance with the instruc-
This Class B digital aparatus complies with the Canadian RSS-210.
tions, may cause harmful interference to
IC: 6693A-BETXSA2 CAN ICES-3 (B)/NMB-3(B)
radio communications. However, there is no
For a complete Declaration of Conformity please contact the
guarantee that interference will not occur
in a particular installation. If this equipment
Bellman & Symfon European office.
Service center
Bellman & Symfon Service Center
for North America
1081 West Innovation Drive
C
US
Kearney, MO 64060
USA
Call 1-877-720-3401 Toll Free
5002353
Conforms to ANSI/UL Std. 217 Cert. to ULC STD S531
Head office
Bellman & Symfon Europe AB
Södra Långebergsgatan 30
421 32 Västra Frölunda
Sweden
Phone: +46 31 68 28 20
E-mail: info@bellman.com
28

Publicité

Chapitres

Table des Matières
loading

Table des Matières