Applications; Installation And Connection; Remote Control - Monacor M-32CD Mode D'emploi

2 Applications

The CD player module M-32CD is designed for
installation into a basic unit (e . g . active speaker
system, amplifier) and offers extensive functions,
such as continuous repeat, random replay,
programming of an individual title sequence,
MP3 replay of USB storage media and memory
cards (32 GB max .)* .
It is able to play audio CDs, audio CDs you
have burnt yourself (audio CD-R) and CDs with
titles in MP3 format . However, problems may
occur when replaying rewriteable CDs (CD-RW)
depending on the type of CD, the CD burner
and the burning program used .
* Note: Due to the large number of storage device
manufacturers and device drivers, it cannot be guar-
anteed that all storage media are compatible with
the M-32CD .

3 Installation and Connection

•
The CD player module must only be installed
by qual ified personnel!
•
The module must be installed into the basic
unit in a horizontal way .
1) Prior to the installation of the module,
always disconnect the basic unit from the
230 V mains .
2) To accommodate the module, make a cutout
of 155 mm × 50 mm on the basic unit .
3) Make the electrical connection to the basic
unit:
Marking Core colour
Operating Voltage
+12V red
GND black
Audio Output
L-CH white
S-GND black
R-CH red
4) Push the module through the cutout on the
basic unit and fix it via its front panel with
four screws .
4 Operation

4.1 Remote control

1) To insert the batteries (2 × 1,5 V, size AAA),
2) When you press a button on the remote con-
3) If the range of the remote control decreases,
4.2 Replaying music titles
After applying the 12 V operating voltage, the
CD / MP3 player is switched on . The display will
show
Insert a CD with the lettering facing up into the
slot until it is pulled in automatically
and / or
connect a USB flash drive to the USB port
or connect a hard disk (with individual power
Connection for
supply, if required) to the USB port
and / or
+12 V (0 .8 A)
insert a memory card into the slot SD / MMC
CARD, the notched corner of the card to the
ground
right . To remove the card, slightly push it in to
eject the card from the slot .
left channel
All other operating options are listed in the table
ground
on the following page .
right channel
remove the battery compartment cover on
the rear side of the remote control . Insert the
batteries as indicated in the battery compart-
ment . Close the compartment with the cover .
If the remote control is not in use for a
longer period of time, remove the batteries to
prevent any damage due to battery leakage .
trol, always direct the remote control towards
the module . There must be no obstacles be-
tween the remote control and the module .
the batteries are exhausted and must be re-
placed .
Used batteries must not be placed
in the household waste; always take
them to a special waste disposal, e . g .
collection container at your retailer .
.
Welcome
9