Gnnetcom GN Ellipse Guide D'utilisation page 4

Assembling the GN Ellipse
1. Disconnect handset cord from telephone and connect
it to socket marked
Connect cord with modular plugs (G) to handset socket
marked on the telephone and to socket marked 1 at
the bottom of the base unit. Connect power unit adaptor
(E) to socket marked 2 at the bottom of base unit, and
then to a power socket.
Switch on power.
2. Mount base unit on stand (D) by turning clockwise until secure. The three cords
can extend from the front or back of the base unit as you wish. Mount the
headset stand (B) on top of the base unit.
3. Insert battery (F) at rear of remote unit (C) by sliding into place until it clicks.
4. Connect headset to bottom of remote unit using the
Quick-Disconnect connector.
5. Insert remote unit into base unit. Both sides of base unit
can be used. The battery charging indicator (IV) on base
unit will light up. This side will be referred to as the front
of the base unit.
Before setting up GN Ellipse to your telephone
6. The battery for the remote unit is not charged when delivered. Place remote
unit with battery in base unit for at least 1 hour before making the adjustments
below. It takes 3 hours to fully charge the battery.
Note: If your telephone has volume control, set the volume in the middle
position.
2
at the bottom of base unit (A).