Ec Declaration Of Conformity - Explore Scientific BCC1001 Mode D'emploi

ALARM
SETTING / ADJUSTING ALARM TIME
1.Press [ ] triple to enter alarm 1 setting mode.
The [ ] will be on. (Press four times to enter
alarm 2 setting mode. The [
2. The setting parameter will flash.
3. Press and hold [
and enter to next parameter.
4. Press [ ] or [
5. Sequence of setting: Hour -> Minute -> Alarm
OFF/ON
6. If there is no action in 3 seconds, the setting
will be saved and will exit the setting mode.
OPERATION
1. At the set time, alarm signal rings.
2. The alarm lasts 1 minute.
3. To stop the alarm, press [
4. During the alarm, press any other button to
delay the alarm by 5 minutes.
5. The alarm will start again at the next alarm
time, unless you switch off the alarm function.
NOTE:
a. The alarm will automatically turn off after 4
times of snooze.
b. The screen will be turned on when the alarm
rings during Power OFF.
SPECIFICATIONS
Dimensions (Main unit):
204x79x109mm (LxWxH)
Weight (Main unit):
820 g (Exclude batteries)
Power:
Micro USB charging cable, DC 5V, 1.5A
Bluetooth standard:
5.0
Output Power:
5W * 2
Batteries:
2200mAh*2
6
] will be on.)
] button to confirm setting
] to set the required data.
].
Wireless Charging Power:
5W
Output Voltage:
5V
Output Current:
1A
EC DECLARATION OF
CONFORMITY
Hereby, Explore Scientific GmbH declares
that theequipment type with part number:
BCC1001 is in compliance with
Directive: 2014/53/EU. The full text of the EU
declaration of conformity is available at the
following internet address: www.bresser.de/
download/BCC1001/CE/BCC1001_CE.pdf
RCM DECLARATION OF
CONFORMITY
The product complies with electrical
safety, EMC and radio spectrum regulatory
requirements for products supplied to
the Australia or New Zealand market.
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do
not use any cleaning fluid.
• Protect the device from dust and moisture.