AEG FAVORIT 88072 Notice D'utilisation page 31

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

the same time until the appliance is in
setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
3. Close the appliance door.
4. Make sure that the appliance is in
setting mode.
5. Press Program again and again until
the indicator of the programme that
you want to set comes on.
• The programme duration flashes in
the display.
• The phase indicators of the set
programme come on.
6. If you want, you can set the options.
7. Press Start. The programme starts.
• Only the indicator of the phase in
operation stays on.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with
delay start
1. Set the programme and the options.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Press Start. The countdown starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
• The phase indicators of the set
programme go off.
• When the countdown is completed,
the programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
Press Delay again and again until:
• The display shows the programme du-
ration.
• The phase indicators come on.
• The programme starts.
Cancelling the programme
Press and hold Delay and Start at the
same time until:
• All the programme indicators come
on.
• The display shows 2 horizontal status
bars.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
When the programme is completed, the
end indicator comes on and the display
shows 0.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off
button, the Auto Off device au-
tomatically deactivates the appli-
ance after some minutes. This
helps to decrease the energy
consumption.
ENGLISH
31

Publicité

Table des Matières
loading

Table des Matières