Preparing The Remote Control; Inserting The Batteries; Using The Remote Control - Aiwa HV-FX8100U Mode D'emploi

VCR reception setting
When using the VCR, the signal passes from the antenna to
the VCR and then out to the TV. Before you use the VCR, a
video output channel must be set on your TV.
To AC outlet
When a TV is connected with an antenna
cable
When the TV is connected to the UHF/VHF OUT(TV)
connector using a supplied antenna cable, set the channel
selector at the rear to 3 CH or 4 CH, not employed for
broadcasts, and select the same channel on the TV.
(For watching the VCR, set the channel, 3 ch or 4 ch on the
TV for watching the VCR.)
To select a desired TV channel on the TV
Turn the TV on and turn off this VCR.
To see a TV program or video program selected on the
VCR
Turn the TV and VCR on, and press TV/VCR to display
"VCR" in the display window.
To see a desired TV channel on the TV after playback
Press TV/VCR so that "VCR" disappears from the display
window.
When a TV is connected with an audio/
video cable
When the TV is connected using the supplied audio/video
cable, turn the TV and VCR on, and select the video input
mode on the TV.
VHF/UHF
IN (ANT)
OUT (TV)
CH
3
4
TV/VCR
VCR

Preparing the remote control

Inserting the batteries

Caution
To prevent damage from leakage or explosion, follow
the descriptions below.
• Insert two supplied R03 (size AAA) batteries with the
0 and 9 marks correctly as illustrated.
• Do not mix old batteries with new ones or different
types of batteries.
• Do not throw the batteries into a fire, apply heat to
them or take them apart.
• Do not carry the batteries with keys or other metallic
objects.
Note
Remove the batteries when they have no more power, or when
you do not use the remote control for a long period of time.

Using the remote control

Point the remote control toward the remote sensor.
5m
30
7m
Notes
• The remote control may not operate when there is an
obstruction between the remote control and the remote
sensor.
• Strong ambient light sources such as a fluorescent lamp or
direct sunlight may cause unreliable operation.
• Using a TV with the same type of infrared remote control
facing the same direction may cause incorrect operation.
• The maximum distance for effective control between the
remote control and the remote sensor is 7 meters. When the
maximum operable distance becomes shorter, replace both
batteries with new ones.
• Although you can use the remote control within an angle of
up to 30 degrees in any direction from directly in front of the
remote sensor, we recommend a narrower angle for stable
operation.
30
Remote
sensor
CONTINUE
8
ENGLISH