Joyello MAMMOLA JL-1047 Mode D'emploi page 14

GB
Use only spare parts approved by the manufacturer. Do not apply accessories to the product, which are
not supplied by the manufacturer.
Do not adjust the product with the child inside.
Do not move the product with the child inside.
Do not use the product with more than one child at a time.
The product must be kept away from electric cables and cords: do not place the product near windows
where cords, curtains or similar objects could pose chocking or strangling hazards for the child. To avoid
strangling hazards, do not give to your child or place near him, objects equipped with cords.
A prolonged exposure to the sun may cause changes of tones to the product's colour. After a prolonged
exposure of the product to high temperatures, wait a few minutes prior to placing your child in it.
When not in use, keep the product away from the reach of children.
The packaging (plastic bags, cardboard, polystyrene, etc.) should be kept out of the reach of children,
as they are potential hazardous objects, and should be disposed of in compliance with the current
regulation.
CO-SLEEPING MODE (FIXING TO THE BED)
The crib can be fixed to the parent's bed (co-sleeping mode). WARNING – IMPORTANT FOR THE SAFETY
OF YOUR CHILD: this method is only possible with bed types that comply with all of the conditions
described in this paragraph.
The side support of the crib should always be put close to the parent's mattress and the mattress should
always be aligned with the height of the side support for restraint of the crib. Furthermore, the crib
should be firmly fixed to the structure of the parents bed or to the mattress support.
WARNING: Check to make sure that the crib in the co-sleeping mode does not interfere with the parent's
bed.
WARNING: use the crib with the tube lowered, only in the co-sleeping mode.
WARNING: the height of the parent's mattress should always be more than that of the side support for
containment of the crib.
WARNING: in the co-sleeping mode the 2 legs of the crib should always be adjusted to the same height.
WARNING: before every use always check to make sure that there is no space between the parent's
mattress and the side of the crib. If there is, pull the belts firmly to tighten until there's no space and the
permitted condition of use has been restored.
WARNING: During use, make sure that the parents bed sheets, blankets etc. do not enter and cover the
interior of the crib.
WARNING: Use of the product is only permitted with beds and/ or mattresses with straight sides. Use of
the product with round beds and/or mattresses or water beds is not permitted.
WARNING: When the product is used in the "Co-Sleeping Mode" (fixing to the bed), it should always be
fitted to the long side of access to the bed. DO NOT fix the product to the head or bottom of the bed.
WARNING: to avoid death from the infant's neck being caught on the top rail on the side that is next to
the parent's bed, the top rail shouldn't be higher than the parent's bed mattress.
ASSEMBLY
1) Remove all parts from packaging and ensure all parts are present before starting assembly. Insert
support bar (D) to left side frame stand (E) (fig 1) and secure with 2 screws (G) (fig 2). Use the allen wrench
to tighten screws in clockwise direction (fig 3). Repeat for the other side with right side frame stand (F)
(fig 4).
2) Insert the left side frame stand through the casing cloth located on the side of the crib body (A).
Attach the handrail joint to the top of the frame stand tubing as illustrated. The spring stud will click into
place once secure (fig 5). Repeat for the right side frame. Next, insert mattress (B) into the crib.
14