Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation Instructions
1. Power On/O and Auto-o Function
Press button
to turn on the instrument. Press it again for 2 seconds or more to
turn o the instrument.
This light source has a power-saving function. If 10 minutes without any
operation, the
instrument will automatically shut down. If you need to disable this function, only
need to press the button
displays "PERM".
2. Backlight Function
When the instrument is powered on, short press button
backlight function on or o . The backlight function supports you to use the light
source at night or darker occasions.
3. Select Wavelength
After pressing button
The power meter or other measuring instrument should select correspond
wavelength of light source.
4. Modulation Output
After pressing button
This instrument has 3 modulations for selection: 270Hz, 1KHz, 2KHz.
5. Wavelength Identi cation
Press button
, the light source will output with wavelength ID and LCD will
ID
display "ID". If work with the paired power meter with WAVE ID function, the
optical power meter will change to the same wavelength automatically.
for 2 seconds when you turn on the instrument till it
, you can select the required output wavelengths.
, you can load a modulation current output laser.
MOD
, you can control the
6
Publicité
Table des Matières
