Using The Wand; Using The Tools - KENT S12 Mode D'emploi

1
1
3
10
2
2
3
USING THE WAND (OPTIONAL)
The Wand (13) is not supplied as a standard item in all variants
of these machines. To use the wand:
1. Push the machine to upright locked position. The brush motor will
then stop (Dual-version only), and the brush will be lifted up
from the surface on single motor versions.
Then slide the Wand out of its holder.
2. Use the wand for cleaning hard to reach places like fl oor corners,
or furnitures.
USING THE TOOLS (OPTIONAL)
These tools are not standard items in all machine variants.
Use these tools for a better cleaning performance at hard to reach
areas. A Crevice Tool (14) and Upholstery Tool (21) is placed
conveniently on the machine, just behind the wand.
Remove the wand from the vacuum cleaner and you will have free
access to the Tools.
1. The Upholstery Tool is placed in the upper section of the cleaner.
2. The crevice tool is placed in the lower section of the cleaner.
3. Install the Crevice Tool or Upholstery Tool on the end of the Wand,
or on the end of the hose, which can be detached from the wand, if
desired. Now the vacuum cleaner will have an extended coverage
performance and can be used for cleaning hard to reach areas like
roof strips, or furnitures.
IMPORTANT !
Foot pedal must be used
to release base to
operating/non operation
position. Failure to do so
could result in damage to
the release
mechanism.
IMPORTANT !
Foot pedal must be used
to release base to
operating/non operation
position. Failure to do so
could result in damage to
the release mechanism.