Menu Selection - Nexo NX242 Manuel D'utilisation

HEADROOM adjustement allows the signal to be scaled to the Analogue to Digital
High end AD converter :24bit allowing a 110dB Dynamic range (analogue to analogue)
In this slot goes the optional NXtension-CAI and NXtension-ES4 Expander Boards.
Yellow LED Protections : Prevent speaker Displacement and Temperature failures
Green LED Signal : Monitor amplifier signal & displays sense error alerts.
Connect your NX242 to the COM port of your PC to update the NX242 Firmware.
Allows the best use of the protection process, including the amplifier analysis (gain and
clipping voltage). Failing to connect the sense connector may damage your speakers.
Allows continuous operation between 90V and 260V. No Adjustment required.
USER MANUAL LOAD2_22
DATE: 03/12/2004
SETTING-UP ADVICE
High end Floating balanced Input
Maximum Clipping input : 28dBu
Nominal Input impedance : 19.8kOhm
Common Mode Ratio (CMRR): 85dB
Very High Immunity to common mode interferences
Converter, keeping the unity gain of the NX242
Blanking panel
Mute & Solo Buttons
Red LED : Muted Channel
Channel monitoring
Red LED Peak Limiting : Prevent your amplifier from overloading
LCD contrast adjustment
Input Overload / DSP Clip
Heavy Duty Balanced Output Stage.
High end DA 24bit convertion
Delivers up to 28dBu into 600Ohm load
Rotary Encoder
Enter Button
Serial Connection RS232 to PC
Sense Line Connector to amplifier
LCD screen

Menu Selection

Sub Menu B Selection
Main Menu A Selection
Switch mode power supply
Detachable Power cord shall comply with your country regulation.
ON/OFF Mains Switch
11
PAGE