Prodipe A1 Duo Manuel Utilisateur page 7

Frequency response graph:
Connecting and Disconnecting the Microphone Cable:
1. Insert the XLR connector into the microphone. If necessary, rotate the connector to align the key on the
connector and the groove in the microphone. Push the connector into the microphone until clicks.
2. To disconnect the cable and microphone, grasp the connector while depressing the tab. Pull the
connector away from the microphone.
"Low cut" switch:
(Low frequency attenuation):
Position "-": no attenuation.
"┌" position: reduces the background noise effect
while minimizing the risk of feedback.
Prodipe and its distributors decline all responsibility for any damage caused by using this appliance in a
way that does not conform to the conditions of use as set out above.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2016 IPE Music/Prodipe
Page 7