Setting The Frequency Manually; Selecting A Frequency From A Group; Adjusting The Transmission Power - JTS MONACOR INTERNATIONAL UF-20TB/5 Mode D'emploi

1) Call up the setting for the ID No via the
menu item
Device ID
Device ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button
 to deactivate the function (OFF) or the
button  to activate the function (ON) If the
function has been deactivated, the REMOSET
transmission will be possible from any UF-
20R / 5 or UF-20S / 5 receiver; if the function
has been activated, the REMOSET transmis-
sion will only be possible from a receiver with
the same ID No
4) Press the button SET to save the setting
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the pocket transmitter has been set to
the transmission frequency or to the group and
the transmission channel of the receiver, the LED
REMOSET (3) shows blue for five seconds and
the display indicates
If the LED REMOSET does not light up, the
automatic synchronization of the transmitter
has failed In this case, the button REMOSET on
the receiver keeps flashing slowly For trouble-
shooting see steps 1 – 6 at the beginning of this
chapter Check the settings on the transmitter
and possibly on the receiver and correct them
Then press the button REMOSET on the receiver
again
– Disabling the REMOSET function –
The REMOSET function can be disabled to pre-
vent automatic setting:
1) Call up the menu item
menu
Remoset
ON
OFF
2) Press the button  to disable the func-
tion (OFF) or the button  to enable the
function (ON)
3) Press the button SET to save the setting
16
of the main menu
Fig. 8
Sync...
in the main
Remoset
Fig. 9

3.7.2 Setting the frequency manually

1) Call up the frequency setting via the menu
item
Frequency
Frequency
604.375
G:-- C:--
Fig. 10
2) Press the button  or  to set the frequency
in steps of 1 MHz
3) Press the button SET so that the digits after
the decimal point are highlighted To make a
fine adjustment in steps of 0 025 MHz, press
the button  or  If the frequency is identi-
cal to the frequency of a channel in a group,
the group and channel numbers are indicated
in the lower line
4) Press the button SET a second time to save
the frequency selected

3.7.3 Selecting a frequency from a group

1) Call up the group and channel selections via
the menu item
Group/Chan
menu
Group/Chan
G: 2
C: 1
530.375 MHz
Fig. 11
2) Press the button  or  to select the group
3) Press the button SET to highlight the channel
number Then press the button  or  to se-
lect the channel The corresponding transmis-
sion frequency is indicated in the lower line
4) Press the button SET to save the setting

3.8 Adjusting the transmission power

1) Call up the menu item
RF Power
High
Low
2) Press the button  for the setting
the button for the setting
= high power (50 mW): high range,
High
but short battery life
= low power (10 mW): long battery
Low
life, but short range
3) Press the button SET to save the setting
of the main menu
of the main
RF Power
Fig. 12
Low
High
or